Idiomas disponibles
Idiomas disponibles
6.
Programming the Operator
6.1
Keep trolley locked,Pull and push the door by hand,make sure the trolley
6.1.1
connects with the shuttle.
Turn on the power, the courtesy light is on
6.1.2
same time, the LED displays the number from 99 to 11.
Then the operator turns to standby situation.
At last, it displays " - - ".
6.1.3
6.2
Press and hold SET until it displays "P1".
6.2.1
Press SET, it displays "OP".
6.2.2
Then press
6.2.3
W``hen the door has reached the open position,
6.2.4
It displays "CL".
Then press and hold DOWN, it flashes "CL". When the door has
6.2.5
reached the closed position, press SET.
The door opens and closes automatically to map the open and close sensitivity
6.2.6
force requirements.
It displays "- - " to show setting is complete.
6.2.7
6.3
When the unit has stored 20 codes, it flashes "Fu", or preventing
6.3.1
coding mistakes, it is necessary to cancel all the stored codes.
Press and hold CODE , it displays "Su " .
6.3.2
Hold more than 8 seconds, it flashes "dL" , all the codes were
6.3.3
cancelled.
6.4
Press CODE, it display"sSu ".
6.4.1
Press a button on the transmitter, then release and press the same
6.4.2
button again, "Su" flashes,
Then it displays "- - " to show setting is complete. Repeat up steps to code
6.4.3
a maximum of 20 different transmitters' and/or buttons.
Setting Open and Close Positions
and hold UP i , t flashes "OP".
Self Learning Transmitter
Adding or Changing Transmitters
Preparing
for several seconds, at the
press SET,
9
7
