Bulldog DC Serie Manual De Instrucciones página 12

1.6.3 Wireless Remote and Transmitter Installation
1. Install Battery
a. R emove the three screws from the wireless
transmitter.
b. S eparate the top section, insert the battery
positive (+) side up and replace the top
section.
c. Replace the three screws.
2. Test
a. Press the Power Button for 5 seconds until the Green light comes on.
b. Press the In/Down or Out/Up button. The Red indicator light will come on.
Power Button
Cable IN
3. Stop
a. T he system will automatically shut down the
transmitter if not activated for 5 minutes.
b. P ress and hold the Power Button for 5 sec-
onds to shut down the transmitter.
4. Reset
a. Press and hold the Programming Button for 5 seconds until the Red indicator illuminates.
b. Press the Power Button on the transmitter for 5 seconds until the Green indicator lights up.
c. P ress the In or Out button on the transmitter until the Red indicator light on
the receiver turns off.
d. Reset is now completed. Please note only one remote transmitter can be reset for each receiver.
5. Notes
a. The wireless remote control and wired remote can be exchanged for activating the winch or jack.
b. B linking Green LED light shows the transmitter battery is low, the battery should be replaced
immediately.
c. P lease note only one remote can be reset for each receiver.
d. Blinking Red LED for poor signal.
12
CEQUENT
Installation Instructions
Figure 12 - Operations
LED Indicator
Cable OUT
PERFORMANCE PRODUCTS, INC. •
™
Figure 11 - Battery Replacement
Lithium Battery:
CR2032 (3V)
Cable IN
Figure 13 - Resting
LED
Indicator
F3837-00 REV B (4782) 08/15
Cable OUT
Programming
Button