Idiomas disponibles
Idiomas disponibles
Improve your indoor air quality with your new Pureguardian Air Purifier with a removable evaporative
Humidifier. The HEPA filter captures allergens and includes a charcoal filter layer to help reduce
household odors.
IMPORTANT: The humidifier can only be used when the air purifier is in use. It uses the exhaust
air from the air purifier to disperse moisture into the air. The air purifier can be used independently.
AIR PURIFIER OPERATING INSTRUCTIONS
IMPORTANT: The air purifier is shipped with the filter stored in the filter compartment.
The filter is shipped in a bag to prevent degradation. Before using, remove and discard bag.
Note: Proper filter and filter panel installation is necessary for the unit to turn on and run.
BEFORE OPERATING THE AIR PURIFIER:
1. Select a firm, level and flat location for the air purifier.
• For proper air flow, locate the unit at least 1 foot from any wall or furniture.
• Make sure none of the grills are blocked.
2. Plug the power cord into a 120V AC outlet. An audible chime will sound when plugged in.
OPERATING THE AIR PURIFIER
1. Turn unit power ON by pressing the power button on the top of the unit.
Note: The purifier will not work if the back panel is not closed. The first time the unit
is plugged in and power on, the air quality sensor will take a few minutes to calibrate.
2. Select Fan Speed Mode 1, 2, 3 (high).
3. Timer - If you prefer to run the purifier for a specific number of hours. Press timer
control to select hours – 1, 2, 4 or 8 hours as indicated by the lights above the button.
To cancel timer: hold the timer button for 3 seconds.
4. Sleep Mode - Press to dim display lights. When selected, the lights will dim and the
air purifier will run in low speed. Press any control to exit from sleep mode.
5. Auto Mode - Press the fan speed button until the indicator in front of "A" lights up.
A
When in "Auto" the fan speed will change depending on the air quality level in the room.
See AQM below.
6. Child Lock - Press and hold Sleep + Fan controls for 3 seconds to lock control panel
so controls cannot be adjusted. Press and hold for 3 seconds again to turn feature off.
7. Filter Change Indicator lights to indicate it is time to change the filter. Replace the filter
according to instructions (Pg. E-6). Press and hold Timer + Sleep Controls for 3 seconds
to reset the reminder.
8. Air Quality Monitor (AQM): detects the amount of particulate matter (PM2.5) in the air.
The light bar under the display is the AQM indicator and it will change colors, indicating
the air quality level in the room. The particulate matter value will be displayed on the
control panel. See values and status ranges in chart below.
Light Color Particulate Matter Value (Range) Air Quality Status Auto Fan Speed
Green
Yellow
Red
AIR CLEANING SYSTEM
OPERATING INSTRUCTIONS
0-100
101-200
201-500
Good
1
Average
2
Poor
3
E-5
