Idiomas disponibles
Idiomas disponibles
2-5
Carrying handle
The carpet cleaner may also be lifted by
placing a hand above the upper clean
solution tank handle as shown.
2-8
Rinse Setting switch
Use this switch to select a wash with
rinse setting or a rinse only setting.
WASH-AutoRinse™ - This setting
cleans your carpet with detergent and
water on the forward stroke. On the
reverse stroke, a water-only rinse is
applied to the carpet.
RINSE - This setting applies water-only
rinse in both the forward and reverse
strokes.
See "How to clean" section for more
details.
8
All manuals and user guides at all-guides.com
2-6
B
Automatic shut off
When the recovery tank (lower tank) is full
the automatic shutoff mechanism will shut
off the carpet cleaner suction (suction will
be noticeably reduced).
At that time, the yellow float disk will rise
to the top of the recovery tank lid (B).
The carpet cleaner will no longer pick
up dirty solution and the motor sound
will become noticeably higher in
pitch.
When this happens, turn carpet clean-
er off and empty recovery tank before
continuing use.
Check clean water tank also; it may
need to be refilled.
Do not use without float and float
retainer in place. If broken or dis-
lodged, take to an Authorized Hoover
Service Center or Dealer for repair.
2-9
C
The tanks
Clean water tank
(upper tank)
The clean water tank (C) holds the water
that will either be mixed with detergent
for cleaning the carpet or floor, or used
to rinse the carpet or floor.
The detergent container (D) is perma-
nently attached to the water tank. It
holds the detergent that mixes with the
water.
2-7
Brush setting selector
Your SteamVac™ carpet cleaner has
three agitator brush settings.
SPILL PICK-UP - brushes OFF for pick-
ing up spills or cleaning carpets and
bare floors when brushing is not
desired.
GENTLE SCRUB - for cleaning ceramic
tile, linoleum, sealed wood floors, and
delicate carpets. The brushes will rotate
at a slower speed.
POWER SCRUB - brushes at maximum
speed for cleaning carpets.
Slide selector button to the desired set-
ting before cleaning.
2-10
D
How to fill
Unplug carpet cleaner from electrical
outlet.
Place carpet cleaner handle in the
upright, locked position.
To remove tank, press down on tank
handle and pull forward.
