Stihl FSA 90 Manual De Instrucciones página 37

8 Assembling the Trimmer
► Place the handlebar (3) in the lower clamp
molding (4).
► Fit the upper clamp molding (2).
► Insert the wing screw (1).
► Swing the handlebar (3) up.
► Tighten down the wing screw (1).
► Remove the screw (6).
► Position the control handle (7) on the handle‐
bar (3), trigger facing the gear housing, and
line up the hole in the control handle with the
hole in the handlebar.
► Fit the nut (7).
► Insert and tighten down the screw (6) firmly.
► Position the throttle cable retainer (10) and the
throttle cable (9) on the shaft.
Do not kink the throttle cable or lay it in tight
radii – make sure the throttle trigger moves
freely.
► Squeeze the throttle cable retainer (10).
The throttle cable retainer (10) engages in
position with an audible click.
The bike handle can be lefton the shaft.
FSA 90 R
► Switch off the brushcutter, push the retaining
latch to position and remove the battery.
1
► Fit the clamp (4) in the loop handle (3).
► Place the loop handle (3) with clamp (4) on the
shaft (5).
► Fit the washers (2) on the screws (1).
► Press the clamp (6) against the shaft (5).
► Insert the screws (1) through holes in the loop
handle (3) and clamps (4 and 6).
► Fit and tighten down the nuts (7) firmly.
0458-709-9821-D
9
10
2
3
4
5
6
7
8.2 Mounting the Barrier Bar
The barrier bar can only be mounted in combina‐
tion with the loop handle.
► Switch off the trimmer, push retaining latch to
position and remove the battery.
1
2
► Insert nuts (2) in the barrier bar (1) so that the
holes line up.
► Fit the clamp (5) in the loop handle (3).
► Place the loop handle (3) with clamp (5) and
barrier bar (4) on the drive tube (6).
► Hold the clamp (7) against the drive tube (6).
► Insert and tighten down the screws (8) firmly.
8.3 Mounting and Removing the
Deflector
8.3.1 Mounting the Deflector
► Switch off the trimmer, push retaining latch to
position and remove the battery.
1
2
The line limiting blade (1) is already installed in
the deflector (2) and must not be removed.
► Push the deflector (2) into the guides on the
housing as far as stop.
The deflector (2) is tight against the housing.
► Insert and tighten down the screws (3) firmly.
8.3.2 Removing the Deflector
► Switch off the trimmer, push retaining latch to
position and remove the battery.
English
3 4
5
6
7
8
3
2
37