Stihl KM 85 R Manual De Instrucciones página 28

English
A
8
9
► Fit the loop handle (4) at a distance of (A)
approx. 20 cm (8 in) forward of the control
handle (8)
► Orient the loop handle
► Tighten the bolts – lock the nuts if necessary
The sleeve (9) is present depending on the coun‐
try and must be located between the loop handle
and control handle.
Always leave the barrier bar attached.
6 Adjusting the Throttle
Cable
A properly adjusted throttle cable is the precondi‐
tion for correct operation in the starting throttle,
idle and full throttle positions.
Adjust the throttle cable only when the machine
is completely and properly assembled.
► Use a suitable tool to push the slide to the end
of the slot (see illustration).
28
► Press down the trigger lockout (1) and
4
7
The engine requires a mixture of gasoline and
engine oil.
Avoid direct skin contact with fuel and breathing
in of gasoline fumes.
7.1
STIHL recommends using STIHL MotoMix. This
pre-blended fuel is free of benzene and lead, is
distinguished by a high octane rating, and
always provides the proper mixing ratio.
STIHL MotoMix uses STIHL HP Ultra two-stroke
engine oil for optimum engine life.
MotoMix is not available in all markets.
7.2
NOTICE
Unsuitable fuels or a mixing ratio that deviates
from the specification can lead to severe engine
damage. The engine, seals, fuel lines and fuel
tank may be damaged if low-quality gasoline or
engine oil is used.
7.2.1
Use only high-quality gasoline with an octane rat‐
ing of at least 90 ROC – leaded or unleaded.
Gasoline with an alcohol component exceeding
10% can cause impaired engine performance in
engines with manually adjustable carburetors
and thus should not be used in these engines.
Engines with M-Tronic deliver full engine per‐
formance using gasoline with an alcohol compo‐
nent of up to 27% (E27).
6 Adjusting the Throttle Cable
2
squeeze the throttle trigger (2) (full throttle
position) – this sets the throttle cable correctly.
Fuel
WARNING
STIHL MotoMix
Mixing fuel
Gasoline
1
0458-462-8721-B