Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Spark Attester Service
Your engine is not factory-equipped with a spark arrester, in
some areas, it is illegal to operate an engine without a spark
arrester. Checklocal laws and regulations. A spark arrester is
availablefrom your nearest Sears service center. If you need
to order a spark arrester, pleasecall 1-888-4-1VlY-HOIVlE
{469-4663).
The spark arrester must be serviced every 100 hours to keep
it functioning as designed.
If the engine has been running, the muffler will be very hot.
Allow the muffler to cool before servicing the spark attester.
WARHIHG
Contact with muffler area can result in serious
burns.
._
Exhaust heat/gases can ignite combustibles,
structures or damage fuel tank causing a fire.
• DO NOTtouch hot parts and AVOID hot exhaust gases.
• Allow equipment to cool before touching.
• Keep at least 5 feet (152 cm) of clearance on all sides of
pressure washer including overhead.
• Code of Federal Regulation (CFR)Title 36 Parks, Forests, and
Public Property require equipment powered by an internal
combustion engine to have a spark arrester, maintained in
effective working order, complying to USDAForest service
standard 5100-1C or later revision, in the State of California a
spark arrester is required under section 4442 of the California
Public resources code. Other states may havesimilar laws.
1.
Remove the four 5 mm screws (A) from muffler
protector (B) and remove muffler protector.
2.
Remove 4 mm screw (C) from spark arrester (B) and
remove spark attester from muffler.
3.
Use a brush to remove carbon deposits from spark
arrestor screen. Be careful to avoid damaging screen.
IMPORTANT:The spark arrestor screen must be free of
breaks and holes. Replacespark arrestor if it is damaged.
4.
Install spark arrestor, muffler protector, exhaust
deflector and muffler in reverse order of disassembly.
Sediment Cup Cleaning
1.
Move fuel valve to "Off" position, then remove fuel
sediment cup (J) and o-ring (K).
2.
Wash sediment cup and o-ring in nonflammable solvent.
Dry thoroughly.
3.
Place o-ring in fuel valve and install sediment cup.
Tighten sediment cup securely.
4.
Move fuel valve to "On" position and check for leaks.
Replace o-ring if there is any leakage.
19
Tabla de contenido
