Airzone Easyzone Serie Guía Rápida página 22

SYSTEM PARAMETERS
Note: Some parameters may vary depending on your system.
•
System address. (Not available on systems with BACnet gateway). This allows you to define
the number of the system in your installation. By default, it displays the value 1. The system
will show the free address values with a maximum value of 99.
EN
•
Radio channel. This allows you to enable/disable the system's wireless association channel.
•
Information. (Only for Airzone Think thermostats). This allows you to display information
about:
- Zone: firmware, zone, association, actuator or communications status.
- System: firmware, settings and information on system and installation controllers.
- Devices: indicates the elements connected to the system.
- Webserver: firmware, IP address, gateway, MAC and PIN.
•
Reset system. (Only available for Airzone Blueface master thermostats). This allows you to
reset the system by returning it to factory settings. To reconfigure the thermostats, go to the
Initial configuration section.
•
Centralized control. This allows you to define whether or not your installation has a
centralized controller. By default, it will be configured as deactivated.
ZONE PARAMETERS
Note: Some parameters may vary depending on your system.
•
Associated outputs. This displays and allows you to select the control outputs associated to
the thermostat.
•
Thermostat settings. This allows you to set up a thermostat as Master or Zone.
*Note: It cannot be configured as Master if there is already another thermostat configured
as such.
•
Control stages. (Only available in installations with AZCE6OUTPUT8 modules). This allows
you to configure the heating and cooling stages in the selected zone or all zones in the
system. The options to configure are:
- Air: Enables heating/cooling by air in the zone selected.
- Radiant (not available in cooling stages): Enables radiant heating in the zone selected.
- Combined (not available in cooling stages): Enables air and radiant heating in the selected
zone and allows the user to select the heating stage desired in that zone: Air, Radiant or
Combined (see Zone settings section on the Blueface thermostat, Heating stages).
- Off: Disables the heating/cooling stage in the zone selected.
•
Offset. This allows you to correct the room temperature measured in the different zones or
in all of them, due to deviations produced by sources of heat/cold nearby, with a correction
factor between -2.5°C and 2.5°C in steps of 0.5°C. By default, it is set to 0°C.
•
Reset thermostat. (Not available in remote zones). This allows you to reset the thermostat
by returning to the initial settings menu.
20