Idiomas disponibles
Idiomas disponibles
GB
MT
and use a lever or wedge to
free the electric chainsaw.
Felling trees
A lot of experience is nec-
essary in felling trees. Cut
down trees only when you
can safely handle the electric
chainsaw. In no case should
you use the electric chainsaw
if you feel unsure about any-
thing.
For safety reasons, we advise inex-
perienced users not to fell any logs
with a rail length which is smaller
than the trunk diameter.
• Ensure that no people or animals are in
the fi eld of action. The safety distance
between the tree to be felled and the
nearest-located workplace must be 2 ½
tree lengths.
• Note the felling direction:
The user must be able to move safely
near the felled tree, to saw off the tree
easily and remove branches.It is to be
avoided that the felled tree snags itself
on another tree. Note the natural felling
direction, which is dependent on the
slope and curvature characteristic of the
tree, wind direction and the number of
branches.
• For sowing work on hillsides, the user
of the chainsaw should stay in the area
above the tree that is to be felled, as the
tree will probably roll down or slide off
downhill after being felled.
• Small trees, with a diameter of 15-18 cm,
can usually be sawn off with one cut.
• In case of trees with a larger diameter,
a notched cut and a back cut must be
implemented (see diagram
44
).
Do not fell any trees when
a strong or changing wind
is blowing, if the danger of
property damage exists or if
the tree could fall on electric
wires.
When felling trees, ensure
that no other persons are
exposed to hazards, that
no supply lines are hit, and
that no property damage is
caused. If a tree should come
into contact with a supply
line, the utility company must
be informed immediately.
Immediately after termination of
the sawing procedure, remove the
ear protection so that you can hear
hooter and alarm signals.
1. Removal of branches:
Remove hanging branches by
positioning the cut from above
the branch. With removal of
branches, never work higher than
shoulder level.
2. Escape area:
Remove the undergrowth around
the tree to ensure an easy es-
cape. The escape area (1) should
be around 45° either side behind
the planned felling direction (2).
3. Cutting notch (A):
Make a felling notch in the direc-
tion in which you wish the tree to
fall. Start with the bottom, hori-
zontal cut. The cut depth should
be around 1/3 of the trunk diam-
eter. Now make a slanted saw
cut from above at an angle of
roughly 45° to meet exactly with
the bottom saw cut.
This helps avoiding that the chain-
