STACK-ON SS-16-MB-B Instrucciones página 2

Idiomas disponibles

Idiomas disponibles

BATTERY
INSTALLATION
Open the ba ery compartment located on the
back of the lock faceplate. See illustration below.
A er ba eries are installed, rea ach the faceplate
by twisting it on in the opposite direction of the
illustration on previous page.
1
Battery
cover
2
Battery
cover
NOTE:
e red reset bu on located on the
inside of the door, is covered with a removable
red cap. When you use the red reset bu on
while se ing your own combination, remove
the cap to access the bu on.
Replace the cap securely over the reset bu on
a er se ing your combination. Failure to do
so will compromise the safety and security of
the safe.
BACK VIEW
Batteries
RECORDING FINGERPRINTS
When you first receive your safe there are no
recorded fingerprints. For security you must
record a fingerprint. Failure to do so will
compromise the safety and security of the safe.
You can record up to 20 different fingerprints for
opening the safe. For best results, each individual
should use their thumb or index finger only.
To record a fingerprint, first press the Reset Bu on on
the inside of the safe.
two beeps (if the sound is turned on) and the green
light flashes twice, you will then record the same
finger three times as follows:
1. Place your finger on the scanner until there
is one beep (if the sound is turned on) and the
green light flashes once. Li your finger off
the scanner.
2. Place the same finger on the scanner for a
second time, holding the finger in the same
position until there is one beep (if the sound is
turned on) and the green light flashes once.
Li your finger off the scanner.
3. Place the same finger on the scanner for a
third time, holding the finger in the same
position until there is two beeps (if the sound is
turned on) and the green light flashes twice.
Li your finger off the scanner. Your fingerprint
is now recorded.
SCAN THE SAME FINGER 3X
If the red light flashes three times with three beeps
(if the sound is turned on) your fingerprint did not
get recorded and you will have to start over.
If you enter more than 20 fingerprints, the red light
will flash 5 times and there will be 5 beeps
(if the sound is turned on).
NOTE: In certain dry climate conditions, your
fingerprint may not scan. If your fingerprint did not
scan, we recommend moisturizing with minimal
lotion and trying again.
e scanner will turn blue with
40677-2203
2
14
loading