Cheyenne HAWK PEN UNIO Instrucciones De Uso página 33

5 Preparing the tattoo ma-
chine for use
NOTICE
Damage from condensate
If the machine is exposed to significant
variation in temperature, e.g. during trans-
port, condensate can form inside, which
may cause damage to the electronics.
Ensure that the machine has reached
E
ambient temperature before using it. If
it was exposed to high temperature
fluctuations, wait for at least 3 hours
for every 10 °C of temperature differ-
ence before putting it into operation.
Only use the device at ambient tem-
E
peratures of +10 °C to +35 °C.
Cheyenne HAWK Pen Unio
5.1 Checking equipment
Conduct a visual inspection of the
E
equipment:
– Are there any visible signs of ex-
ternal damage (e.g. loose or bent
components?)
– Are there any exposed cables?
– Are the needle cartridge and the
needles correctly aligned?
Switch on the machine and conduct a
E
noise test: Can you hear any unusual
operating noises, or is the unit run-
ning loudly?
If you detect anything unusual, refer
E
to chapters 10 on page 41 and
11.1 on page 42.
If the machine is no longer operating
E
safely, take it out of service and con-
sult your local specialist retailer.
5.2 Disinfecting equipment
NOTICE
Damage to drive caused by fluid
If disinfectant gets inside the drive, this
may corrode the electrical and mechanical
components.
Never immerse the drive in disinfec-
E
tant.
NOTICE
Product damage caused by non-ap-
proved disinfectants
Disinfectants that are not compatible with
the materials of the product may damage
its surface.
Always use disinfectants that are ap-
E
proved, i.e. that comply with stipula-
tions in your country.
E Note the list of recommended disinfec-
tants in chapter7.1 on page 38.
EN 33