Cebora SYNSTAR TWIN 270 T Manual De Instrucciones página 25

Ocultar thumbs Ver también para SYNSTAR TWIN 270 T:
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 67
Open the mobile lateral side, mount the wire coil on its support, insert the wire coming out of the wire coil into the gear
motor, and make sure that wire type and diameter are the same as drive roller ones. The wire must be aligned with the
roller race and come out of the adapter C. Close the drive arm, fit the welding torch and the earth cable on socket D.
After fitting the reel and torch, switch on the machine, select the synergic curve suitable to the type of wire to be
welded, following the instructions given in the service functions (PROCESS PARAMS) paragraph. Remove the gas
nozzle and unscrew the current nozzle of the torch. Press the torch button until the wire comes out. BE CAREFUL to
keep your face away from the end lance while the wire is coming out, screw up the current nozzle and fit the gas
nozzle.
Open the canister adapter and adjust the gas flow to 8 – 10 l/min.
During welding, the display screen A displays the actual work current and voltage. The displayed values may be slightly
different to those set. This can depend on numerous different factors - type of torch, thickness different to nominal
thickness, distance between current nozzle and the material being welded, and the welding speed. After welding, the
current and voltage values remain stored on the display A. To display the set values, the handle B will have to be moved
slightly, while, by pushing the torch button without welding, the display screen A shows the empty voltage value and
a current value of 0.
4
CONTROLS LOCATED ON FRONT PANEL
E
Art.
344
SYNSTAR TWIN
SYNSTAR TWIN
C
TORCH
TORCH
®
3301051/B
ZONA NON ADESIVA
ZONA
TRASPARENTE
PUSH PULL
PUSH PULL
TORCH
TORCH
270 T
A – DISPLAY SCREEN�
This displays both the welding parameters and all the
welding functions.
A
C – CENTRAL ADAPTER :
Connect the welding torch
B
C1 – CENTRAL ADAPTER.
This is where the welding torch or the Push-Pull system
C1
torch is to be connected.
D – SOCKET (-): this is where the earth cable is to be
connected.
D
E– CONNECTOR : For connecting remote controls and
the welding control cable Push–Pull Art�
25/33
loading

Este manual también es adecuado para:

344