Pre-Operation; Operation; Operating Procedures - Skymsen DAL-06 Manual De Instrucciones

It is recommended to install the machine near a water sink connecting it with a pipe
to the water Exit Pipe #.5 (Pict.01). .Install also a ¾" water inlet pipe and connect it to the Water
Entrance Nipple # 01 (Pic 01 ) .
Picture - 03
Nipple
Water entrance to be
connected to the nipple
Water Exit Pipe
For water and residues .
Install the machine near a water
sink .
The water outpour jet shall not drop beyond the disc centre as shown on drawing # 01
The water outflow shall not exceed 2.5 quarts per minute
Drawing - 01
WATER ENTRACE
DISC
2.2 Pre Operation
Check the Disc #.06 (Pict.01) is perfectly fitting on to the central Shaft Pin #.02 (Pict.02)
before to switch the machine ON .
Be sure the Garlic Peeler is stable . Install the water entrance and exit (Pict.03)

3 Operation

3.1 Operating Procedures

Never place the hand on the Disc while it is on movement .
Firstly check if the lid #.04 (Pict.01) is perfectly fitted on the machine . To start the Garlic
Peeler , .place the Switch #. 02 (Pict.01) on position ON . With the machine running, drop the product
inside and open the water to flow during the whole peeling process.
For Model DAL-06 maximum load is 4 kg. The processing time will be around 3 to 5
minutes . Trough the lid opening it is possible to watch the process to know when the product is
peeled. After, switch OFF the peeler and wait until the disc stands still Remove using your hands
the peeled product from inside the machine through the lid opening . ..
Product Entrance
It is mandatory to let water flow
directly on the product
METALÚRGICA SIEMSEN LTDA.
WATER OUTPOUR JET
IMPORTANT
IMPORTANT
04