Idiomas disponibles
Idiomas disponibles
ENGLISH
8.2 Cleaning the saw
WARNING: When cleaning the chain saw power head, do not immerse in water or other liquids.
a. Remove battery pack before cleaning.
b. Remove wood chips and other debris from the battery holder. Make sure the contacts are clean
and dry.
c. After use, clean debris from the chain and guide bar. Wipe power head with a clean cloth moiste-
ned with a mild soap solution. Never use harsh cleaners or solvents.
d. Always clean out wood chips, saw dust, and dirt from the bar groove when replacing the saw
chain.
8.3 Periodically
a. Drive Sprocket: Look for deep grooves, broken teeth, or burrs.
b. Bar-Mounting Area: Make sure the bar- mounting stud is not bent, stripped, or cross-threaded
and that the bar pad and alignment flange are free of debris and intact.
c. Charger: The charger should be clean, dry, and free of punctures or other damage. The battery
tray and contacts should be free of debris.
8.4 Replacing the guide bar and saw chain(fig.20)
a） Wear gloves and the chain saw off and cool and the battery pack removed.
b) Loosening bar adjustment locking knob （8） counterclockwise one or two full turn.
c) The chain tensioning knob （7） must be rotated counterclockwise to its stop.
d) Bar adjust locking knob （8） should be rotated counterclockwise to its stop.
e) Then take off the side cover.
f) Last you can take off the worn bar and chain and make sure the bar pad, sprocket, and tensioning
knob are free of debris.
8.5 Install new guide bar and saw chain
PLEASE REFER TO 5.1
18
