Idiomas disponibles
Idiomas disponibles
Installing the Shelves
1.
Open the door completely.
2.
Line up the shelf notches with the rail posts on both the right and left sides.
3.
Push the shelf down and then push it all the way inwards until the shelf fully
rests inside of the unit and you are able to close the door.
4.
The shelf should glide smoothly back and forth. If it does not, you may need to
remove it and start over.
Removing the Shelves
1.
Open the door completely.
2.
Remove all of the contents loaded on the shelf, if applicable.
3.
Line up the shelf notches with the rail posts as indicated below. This will
require you to hold on to both rails as you move the shelf to line up the posts
with the notches on both sides of the shelf.
4.
Evenly life the shelf up and then pull the shelf out.
Changing door opening side
1.
Tilt the wine cabinet 45 degrees upwards and unscrew the lower right hinge
with a screwdriver. (Figure 1)
2.
Lay the wine cabinet flat, hold the door, and unscrew the hinge on the right
door with a screwdriver. Then take it out and place it carefully, and turn the
door 180 degrees. (Figure 2, Figure 3, Figure 4)
3.
Remove the limit bar B, unscrew the screw on the limit bar A with A
screwdriver, take out the limit bar A, move it to the right to the other set of
corresponding screw holes on the shell, tighten the screw, install the upper
limit bar B, and then install the door with the screw and adjust it. (Figure 5,
Figure 6, Figure 7.
EN
31
