Idiomas disponibles
Idiomas disponibles
Starting the appliance
Press the start/stop button for about 3 seconds
Do the same to turn it off.
Temperature control
Press and hold the temperature setting button for three seconds to display
the actual temperature, and press any button to return to display the set
temperature.
The internal temperature is regulated by the electronic thermostat controlled by
the buttons inside the appliance.
Each time the "upper zone" or "lower zone" key is pressed, the selected zone
is incremented by one degree. To obtain a temperature lower than the one
indicated, You can adjust the temperature degree by degree.
After the temperature is selected, the display will flash for 5 seconds and display
the set-point temperature.
Control of the light
To turn on or off the internal light, press the button.
The (LED) light is suitable for the conservation of wine. In order to reduce energy
consumption, the LED light goes off automatically after 10 minutes. However,
we recommend turning off the light under normal use or after each use. However,
if you wish to leave the light on, the procedure is as follows; press button 2 for at
least 5 seconds; the display will then show "LP".
After a few seconds, the display comes back to the temperature indication and
the light stays on continually. To return to the light turning off automatically after
10 minutes, press button 2 for at least 5 seconds; the display will then show "LF".
After a few seconds, the display comes back to the temperature indication and the
light goes off automatically.
Notes
•
If the unit is unplugged, power lost, or turned off, you must wait 3 to 5
minutes before restarting the unit. If you attempt to restart before this time
delay, the Wine cooler will not start.
•
When you use the Wine cooler for the first time or restart the Wine cooler
after having been shut off for a long time, there could be a few degrees
variance between the temperature you select and the one indicated on the
LED readout. This is normal and it is due to the length of the activation time.
•
Once the Wine cooler is running for a few hours everything will be back to
normal.
EN
35
