Idiomas disponibles
Idiomas disponibles
Starting and stopping the multi-tool
1.
Press the "ON/OFF" switch and touch the cutting
adapter or bit to the surface or screw to be cut or
screwed in respectively;
2.
To increase and decrease the rotation speed,
press or release the "ON/OF" switch respectively.
The maximum speed is reached with the switch
fully pressed;
3.
To switch off the multi-tool, release the "ON/OFF"
switch;
During multi-tool operation, the Led light turns on.
Starting and stopping the multi-tool
Do not change the direction of rotation while the multi-
tool is in operation, it can cause serious damage to the
multi-tool. Always check the direction of rotation before
starting to use the multitool.
1.
Use forward/reverse switch to select the direction
of rotation of the shaft:
▪ With the switch on the left, the shaft rotates
clockwise;
▪ With the switch on the right, the shaft rotates
counterclockwise;
▪ With the switch on the middle position, the
"ON/OFF" switch is locked;
Automatic Brake of Magnetic Drill Chuck
The power tool is equipped with an automatic brake on
the magnetic drill chuck. When the "ON/OFF" switch is
not pressed, the magnetic drill chuck rotation is
blocked. This makes it possible to use the multi-tool
(even if it runs out of battery) as a hand tool.
Angle adapter/ Eccentric adapter
The angle adapter, allows screwing in places of difficult
access. The eccentric angle adapter allows screwing
near edges. The adapters can be assembled at different
angles.
Drill chuck adapter
The drill chuck adapter allows the torque to be adjusted
according to the size of the screws.
To select the desired torque, rotate the selector
according to the scale.
28
All manuals and user guides at all-guides.com
For small screws, use lower torque positions. For larger
screws, use higher torques.
Cutting Adapter
The cutting adapter, allows paper/cardboard cutting.
Felt: 6mm; Cardboard: 3.4mm; Corrugated Cardboard:
5mm.
MAINTENANCE AND CLEANING INSTRUCTIONS
Before performing any verification, maintenance or
cleaning work, place the direction of rotation selector in
the central position.
The multi-tool is designed to operate for a long period
of time with minimal maintenance. For continuous and
trouble-free operation, it must be properly maintained
and cleaned regularly.
Cleaning and storage
Cleaning
After each use clean all the components of the power
tool. Clean the tool with a clean, damp cloth or blow
with low pressure compressed air.
A careful handling protects the equipment and extends
its service life.
This multi-tool and its ventilation openings must be
always clean. Clean it regularly or every time they get
obstructed.
Storage
Every time the power tool isn't being used, store it
inside dry, clean and corrosive steam free places away
from children's reach.
