Idiomas disponibles
Idiomas disponibles
Maintenance
34
33
7
12
22
Step 1
23
Step 2
26
Step 5
22
Step 4
Step 3
34
33
35
B C
A
1
86452440 Manual Ranger 12 120V 60Hz
Maintenance and Care
Before performing any maintenance or cleaning,
switch off unit and disconnect plug from wall outlet.
Removal of brush roller
In order to remove the brush roller of the power head,
firmly press the button marked "PRESS" (23). Now
you can swing the bearing block (22) downwards and
remove it. Turn the brush roller (26) a bit clockwise
and pull it out. It has been proven good practice to
check the brush roller regularly for coiled yarn or hair
and remove them.
Removing blockages
If only a slight suction effect is noticeable or if the
brush has been blocked, there may be a clog in the
air passage. On the bottom side of the power head,
the cover (33) of the air duct can be opened by
releasing latch (34) in order to remove clog from the
air channel. Make sure that there is no clog beneath
this cover or in the transitions to brush channel and
turbine.
When closing the cover (33), make sure latch (34)
snaps correctly into the locking hole (35).
If you suspect a blockage or clog in the filter compart-
ment (please refer to pictures on page 9), unplug
mains power cord on machine side (27), remove
screw (7) and separate power head (2) and filter
compartment (1). The air channel in the filter
compartment can be checked easily from bottom. Do
not try to open air channel in filter compartment! If
latches break, machine will not work correctly any
longer.
Under no circumstances blockages or clog may be
cleaned by means of sticks or other hard or solid
tools. Damages would be very likely.
