Idiomas disponibles
Idiomas disponibles
• Brush or blow dust and debris out of the air
vents using compressed air or a vacuum.
Keep the air vents free of obstructions,
sawdust, and wood chips. Do not spray,
wash, or immerse the air vents in water.
• Wipe off the housing and the plastic
components using a moist, soft cloth. Do
not use strong solvents or detergents on
the plastic housing or plastic components.
Certain household cleaners may cause
damage or cause a shock hazard.
• Routinely clean out the dust and debris
that gathers under the tension housing,
the oil outlet, and around the bar and the
chain sprocket. Otherwise it can jam up
the sprocket, the chain, and the lubrication
system.
356 mm (14 inch)
140SDEA041 91P052X
WWW.SENIXTOOLS.COM
1. Rotate the side cover lock and remove the
cover of the saw's body (Figure 8).
in the guide bar.
3. Place the new chain in this position,
making sure the teeth are facing the correct
into the slot around the guide bar (Figure 9).
4. Replace the cover and tighten the side
cover lock. Adjust tension before operating.
Oregon Cutting System
17
