Idiomas disponibles
Idiomas disponibles
The recommended locking torque of the locking block/expander is 6Nm.
To avoid damaging the frame, it is recommended to use a 4 mm hexagonal insert 100
mm long (see image 6a) and to use a torque spanner to tighten the latch/expander
block screw (see image 6b).
DANGER! The clamping block is equipped with an M5x35 mm screw, only
use the specified screw.
The use of a screw longer than 35 mm may result in the horizontal tube of
the frame breaking, otherwise a shorter screw may compromise the tight-
ness of the seatpost/expander clamping block resulting in sudden lowering
of the seatpost and possible falls.
DANGER! Observe the tightening torque specified on the lock/expander block. Incorrect tightening may cause the component to malfunction
and consequently falls!
WARNING! When pulling out the seatpost, do not exceed the safety limit marked on the seatpost (see image 7)
IMAGE 7
OLTRE, OLTRE PRO, OLTRE RC SEAT POST
The supplied seat post is a specific component of the Oltre, Oltre Pro and Oltre RC frames. Without it it is not possible to assemble and use the frame.
The 'headstock' saddle clamping mechanism is made by the manufacturer Ritchey. Please refer to the Ritchey manual supplied with the product for the
saddle assembly procedure.
It should be noted that failure to comply with the warnings and prescriptions contained in this package insert exempts the manufacturer from any
liability.
DANGER! Observe the tightening torque specified on the lock/expander block. Incorrect tightening may cause the component to malfunction
and consequently falls!
WARNING! When pulling out the seat post, never exceed the safety limit marked on the seat post (see image 8)
In the event of an accidental fall or crash, the saddle and seat post will almost certainly be affected. They will
be subjected to severe stress and impact. Deep scratches and cracks indicate that the parts must be replaced.
Contact an authorised dealer immediately.
WARNING! When pulling out the seat post, never exceed the safety limit marked on the seat post (see image 8)
IMAGE 8
INTERNAL BATTERY ASSEMBLY IN THE SEAT POST
COMPONENTS:
1. Shimano Di2 BATTERY
2. Expander for battery fixing on seat post
3. Battery support (C1356225)
4. Screw M4 x 20 mm Torx T20 ISO 14579 locking expander bloccaggio espander (C8655859)
5. Screw M3 x 8 mm Torx T10 ISO 7380-1 battery locking screw on support (C8655744)
IMAGE 6A
IMAGE 6B
A. Insert and place the battery (1)
B. Insert the supplied M3 screw (5) and close the battery (1) with a torque wrench Torx T10 applying
in the holder (3).
a maximum torque of 1 Nm.
C. Insert the supplied M4 screw (4) and assemble
the expander (2).
E. Lock the battery assembly in the seat post using a torque wrench Torx T20 applying a maximum
torque of 2 Nm.
2 Nm
1 Nm
D. Insert the battery assembly into the Bianchi "Oltre" seat post.
BACK
PART
FRONT
PART
