Tabla de contenido
Idiomas disponibles
Idiomas disponibles
SYMBOLS
The followings show the symbols used for tool.
V............................volts
A ...........................amperes
Hz..........................hertz
....................alternating current
.......................no load speed
.......................Class II Construction
.../min....................revolutions or reciprocation per
minute
FUNCTIONAL DESCRIPTION
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before adjusting or checking function on
the tool.
Switch action
CAUTION:
•
Before plugging in the tool, always check to see
that the switch trigger actuates properly and returns
to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
For continuous operation, pull the switch trigger and then
push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
USD201-2
002629
1. Lock button
1
2. Switch trigger
2
Reversing switch action
This tool has a reversing switch to change the direction of
rotation. Press the upper side (FWD side) of the revers-
ing switch for clockwise rotation or the lower side (REV
side) of the reversing switch for counterclockwise rota-
tion.
CAUTION:
•
Always check the direction of rotation before opera-
tion.
•
Use the reversing switch only after the tool comes
to a complete stop. Changing the direction of rota-
tion before the tool stops may damage the tool.
Hook
The hook is convenient for hooking the tool to your belt. It
can be installed on either side of the tool. To remove it,
pull it out in the direction of the arrow while raising. To
install the hook, push it down until it "clicks" into place on
the tool.
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
4
002636
1. Reversing
switch
1
002648
1. Hook
1
Tabla de contenido
