Makita 6833 Manual De Instrucciones página 5

Installing or removing the bit
Loosen the thumb screws which secure the casing. Pull
out the casing in the direction of the arrow.
1
2
Press the dust cover toward the plain bearing and pull
out the bit. If the dust cover cannot be moved as far as
the plain bearing, try it again after turning the bit slightly.
To install the bit, insert it into the socket while turning it
slightly. After installing, always make sure that the bit is
securely held in place by trying to pull it out.
1 2
3
Setting for desired screw length
1
There are 3 (for Model 6833) or 5 (for Model 6834) posi-
tive-lock screw length settings. To obtain the desired set-
ting, pull out the stopper base while depressing the lever
until you see the number of the desired screw length
(indicated on the plate) appear to rest on the very top
edge of the casing. See the table below for the relation
between the number indicated on the plate and the
respective screw length ranges.
002656
1. Casing
2. Thumb screw
002657
1. Dust cover
2. Plane bearing
3. Bit
002663
1. Lever
2. Stopper base
3. Plate
2
4. Casing
3
4
Number indicated
on the plate
25/28
32
40
* 51
* 57
(Note) * for Model 6834 only
Adjusting the driving depth
5mm (3/16")
2
B
3
A
Depress the stopper base as far as it will go. While keep-
ing it in this position, turn the adjusting knob until the bit
tip projects approx. 5 mm (3/16") from the stopper base.
Drive a trial screw. If the screw head projects above the
surface of the workpiece, turn the adjusting knob in the A
direction; if the screw head is counter-sunk, turn the
adjusting knob in the B direction.
Installing screw strip
Insert the screw strip through the screw guide. Then
insert it through the feeder box until the first screw
reaches the position next to the driving position.
1
5
Screw length range
25 mm (1") - 28 mm (1 - 1/8")
28 mm (1 - 1/8") - 35 mm (1 - 3/8")
35 mm (1 - 3/8") - 41 mm (1 - 5/8")
41 mm (1 - 5/8") - 51 mm (2")
51 mm (2") - 57 mm (2 - 1/4")
002665
1. Stopper plate
2. Casing
1
3. Adjusting knob
002666
1. Feeder box
1
2. Screw strip
2
3. Screw guide
3
002667
1. Driving position
002664