Idiomas disponibles
Idiomas disponibles
WARNING! The scale is not waterproof. Avoid contact with water while working with the scale!
3.2.2.
SBS-DFS-11
3.2.2.1.
Turning the scale on/off
Press the "ON/OFF" button to turn on the scale. After turning on the power, all segments of the display will
appear for a few seconds and then "0.00" will be displayed. The scale is ready for operation.
To turn off the scale, press and hold the "ON/OFF" button for about 3 seconds. The scale will turn off
automatically if it is not used for more than 60 seconds.
3.2.2.2.
Weighing
After turning on the scale and the "0.00" on the display, hang the load on the hook and wait for the reading
to stabilize. You will hear a single beep and the display will show a circle symbol in the upper left corner.
Remove the load from the hook, but the scale will not reset - the display will show the value of the load that
has just been measured. At this point, you can do the following:
Reset the load value on the display - press the "0.00" button.
•
Add the load value on the display to the memory - press the "Memory" button (number of memory
•
slots: 0-9).
3.2.2.3.
Tare function
The tare function is the weight of the package itself. It is the difference between the total weight of the goods
with the packaging and the weight of the goods without packaging. The tare is used to remove the weight of
an item that should not be included in the overall weight measurement.
To use this function, turn on the scale and wait for it to stabilize. Then hang a container on the hook, wait for
the reading to stabilize, then press the "ON/OFF" button and wait for the scale display to show "0.000", thus
indicating that the scale is ready for operation. Place the item in the container and the display will show the
weight of the item itself.
3.2.2.1.
Memory function
When the weight value is stable on the display, press the "Memory" button and the weight will be stored in
the memory (number of memory slots: 0-9). When you try to save the eleventh weighing result, the lightest
load value is automatically replaced by this new weight.
3.2.2.2.
Checking/deleting saved data
The scale normally works in the "E" mode - visible on the display in the lower left corner. Mode "E" shows the
sum of the values of the stored weighing data from 0 to 9.
By pressing the "Record" button in series you can check:
1) The first press of the "Record" button - the scale will enter the "C" mode (deletion) and the sum of the
values of the saved data will start flashing. You can delete the sum of the values of the saved data - to do
this, press the "Delete" button.
2) The second and each subsequent press of the "Record" button - the scale will show the recorded data
for slots 0 to 9. In this mode, you can also delete individual data stored under 0 to 9. For example, if you
want to delete data saved under item 2, press the "Record" button until item 2 appears on the display.
Then press "Delete" and the value of data stored in this item will start flashing - press the "Delete" button
again and the entry in this slot will be deleted.
3) Next pressing the "Record" button - the scale will switch to "A" mode - the display will show the average
value of the saved data under 0 to 9.
4) Pressing the "Record" button again will bring the scale back into "E" mode.
WARNING! The scale is not waterproof. Avoid contact with water while working with the scale!
