Idiomas disponibles
Idiomas disponibles
installation area while the pump is
running.
1.4 RESPONSABILITY: The manufacturer
does not vouch for correct operation of
the pump if they are tampered with or
modified, run outside the raccomended
work range or in contrast with the other
instructions give in this manual. The
manufacturer decline all responsibility
for possible mistakes in this instructions
manual, if due to misprints or error in
copying. The company reserves the right
to make any modifications to products
that it may consider necessary or useful,
without
affecting
characteristics.
2
INTRODUCTION
2.1 General provisions
This instruction manual contains general and specific
information regarding the electrical pump that you have
purchased. Follow the instructions given in these booklets
in order to obtain optimum return and operation from
your
electrical pump. If any other information is
necessary, please contact the nearest authorized retailer.
Installation and functioning must comply with the
safety regulations in force in the country in which the
product is installed. The entire operations must be carried
out in a workmanlike manner. Failure to comply with the
safety regulations not only causes risk to personal safety
and demage to the equipment, but invalidates every right
to assistance under guarantee.
Keep this manual with care for further consultation
even after the first installation.
2.2 ATTENTION! Before installation carefully read the
contents of this manual. The demage caused by ure to
follow instruction may not be covered by the warranty or
in any way attributable to the manufacturer.
2.3 The reproduction, even partial, of the illustrations
and/or text herein is forbidden.
3
APPLICATIONS AND LIMIT FOR USE
3.1 Applications
Submersible Multi stage Pump with centrifugal radial
impellers. Designed to handle clean water at a maximum
temperature of 35°C. and max content of sand 60 gr/m3.
Maximum numbers of intervention 40/h. Maximum
immersion depth indicated on the pump's label.
Use the pumps in respect of the technical characteristics
listed in"Annex B".
3.2 Limit for use
The temperature of the liquid to be pumped should
not exceed the maximum level indicated on the technical
chart.
The electric submersible pumps must not absolutely
work without water. If there is any chance that the level of
water can decrease till a minimum point where the pump
will work dry, without water, you will need to install a
the
essential
minimum-level sensor as a safety measure.
The pump can not be used in swimming pools, ponds
or tanks in witch people are present.
The electric pumps are not suitable for use with
corrosive or abrasive liquids, fuels or any other chemical
and explosive products. If any chemically aggressive agents
may be present in the liquid to be pumped, then the
resistance of the materials used in construction must be
verified prior to use.
The liquid used in the pumps for lubrificating the
sealing device is not toxic , but it could modify the features
of the water (in case of pure water) if there were any leaks
in the seal.
4
TRANSPORT, MANAGEMENT AND DISPOSAL
4.1 Transport
The electrical pumps must never be carried or lifted
by their power cable, by float or by delivery pipe. Use only
the handle applying eventually a rope or chains on it. Lift
the pump using equipment suitable to the pump weight
and dimension.
Avoid subjecting the products to impacts or
collisions.
4.2 Storage
All pumps must be stored indoors, in a dry, vibration-free
and dust-free place, possibly with constant air humidity.
They are supplied in their original packaging and must
remain there until the time of installation. If this is not
possible, the inlet and outlet must be accurately closed.
4.3 Disposal
Do not throw away in the environment.
During disposal of the pump, please comply
rigorously with the regulations in force in your country,
making sure that residues of the treated liquid are not left
inside the pump. Most of pumps do not contain hazardous
polluting material.
Information on the disposal of electric and electronic
equipment in compliance with directive 2012/19/UE
(RAEE).
Warning: do not use the normal house trash bin to dispose
of this product. Used electric and electronic equipment
must be handled separately and in compliance with the
regulations relating to the treatment, recovery and
recycling of the said products. In accordance with the
regulations applied in the member States, private users
resident in the EU can take used electric and electronic
equipment free of charge to designated collection centers.
If you experience difficulties in locating an authorized
disposal center, consult the dealer from whom you
purchased the product. The national regulations provide
sanctions against whoever unlawfully disposes of or
abandons waste of electric or electronic equipment.
5
ELECTRICAL CONNECTION
CAUTION! ALWAYS FOLLOW THE SAFETY REGULATIONS!
5.1 SPECIALIZED PERSONNEL: The electrical installation
must be carried out by skilled electrician who assumes all
the responsability.
5.2 Connection
Ensure that the mains voltage and frequency are the
same as that shown on the plate of the motor, and that
there is the possibility of making a good earth connection.
It is advisable to reserve an electric power line
ENGLISH
