Idiomas disponibles
Idiomas disponibles
Install the hob in the opening
Using an electrical cord, connect the hob according to electrical diagram provided
Remove dust from the worktop, insert hob into the opening and press in firmly
Tips for the installer
The hob is equipped with a terminal block allowing different connections appropri-
ate for a specific type of power supply.
Terminal block allows the following connections:
•
Single-phase AC220-240V / 50/60Hz
The hob can be adapted to a specific type of power supply by bridging the ap-
propriate terminals according to wiring diagram. Wiring diagram is placed on the
hob's underside. The terminal block can be accessed by removing the lid on hob's
underside. Remember to match the power cord to the type of connection and the
hob's power rating.
Note: Remember to connect the protective conductor to correctly marked terminal
block clamp. The electrical system supplying the hob must be protected by a prop-
erly selected tripping device or a circuit breaker allowing to disconnect the power
supply in an emergency.
Before connecting the appliance to power, please carefully read the information
provided on the rating plate and wiring diagram. Connecting the hob other than
shown on the wiring diagram may damage the hob.
Note: Electrical connection must be made by a properly certified qualified installer.
Do not make any alterations in the appliance electrical system.
Note: The installer is obliged to provide the user with "appliance electrical connec-
tion certificate" (enclosed with the warranty card). After installation, the installer
should also provide information on the connection made:
•
Single-phase, two-phase or three-phase,
•
Conductor cross-section,
•
Electrical protection (fuse type).
53
