Idiomas disponibles
Idiomas disponibles
10
H D
V er
ri ll
. 1.
1
Te
m p
la te
W a
ll M
o u
( O
n t in
p t io
g T
Wall
n a
y p
l)
e
Wall
Rear
Front
Top View
Wall
Bottom View
Battery
Module B
n t
F r o
R e a
r
SH077064P8S8XXX
Label
Wall
Battery Module Direction
R e a
n t
r
F r o
11
1. Place the Drill template to the wall
where the battery pack will be
installed. After that, drill holes on the
position marked on the Drill template.
* The number of fastener should
observe the regional building code.
LGES recommends the use of at
least 8 fasteners for Wall Mounting
Bracket and 2 fasteners for
Standing Bracket 1.
* Check "Wall Mounting Type
" on the middle side of
Drill Template before drilling.
2. Fix the Wall Mounting Bracket and
Standing Bracket 1 on the wall.
3.
Plate on the Wall Mounting Bracket
using eight (8) M8 Sems Bolts.
* Tighten the M8 Sems Bolts with a
torque of 5N·m(3.7lbf·ft).
4. Place Battery Module B on the rear
side of Module Connect plate.
* The side without bolts is the front
of the Battery Module.
*
battery pack is of B. Label is
attached on the left side of Battery
Module.
Battery Module A
F r o
n t
n t
F r o
SH077064P8S8XXX
Label
Wall
Battery Module B
Rear
Front
Battery Module A
TOP VIEW
Module Support BRKT
Battery Control Unit
Battery Modules
Spacer
TOP
Spacer
(used for assmbly ang disassembly)
Spacer
Spacer
TOP VIEW
5. Place Battery Module A on the front
side of Module Connect plate. The
Rear side of each Battery Module
should face each other.
*
Battery pack is of A. Label is
attached on the left side of Battery
Module.
6. Assemble Module Support BRKTs
using 6 bolts each.
* Tighten the M6 Flange Bolts (x12)
with a torque of 5N·m(3.7lbf·ft).
7. Remove bubble wrap from
connectors of Battery Control Unit
and the warning label of Battery
Modules.
8. Place the spacers on the position
marked with label on Battery
Modules.
