Stihl BG 56 Manual De Instrucciones página 9

To relieve vapor lock:
Press the manual fuel pump bulb at
–
least 20 to 30 times – even if the
bulb is already filled with fuel – to
clear the vapor and send liquid fuel
into the carburetor. Then start the
power tool. For specific starting
instructions, see the appropriate
section of your instruction manual.
If the manual fuel pump bulb will not
–
be filled, place the Choke Knob to
the cold start position g and pull
the starter cord until the engine
runs. If the engine does not fire after
10 pulls in the cold start
position g, place the Choke Knob
to the warm start position < and
start the engine in the warm start
position <.
If your power tool will not restart, or
–
if vapor lock occurs again, the
power tool is being used in
conditions too extreme for the fuel
being used. Discontinue use and let
the engine cool completely before
attempting to start the power tool.
Before Operation
WARNING
Always check your power tool for proper
condition and operation before starting,
particularly the throttle trigger, setting
lever and stop switch. The throttle trigger
must move freely and always spring
back to the idle position. Never attempt
to modify the controls or safety devices.
BG 56, BG 56 C, BG 66, BG 86, BG 86 C, SH 56, SH 56 C, SH 86, SH 86 C
WARNING
Check fuel system for leaks, especially
the visible parts, e.g., filler cap, hose
connections, manual fuel pump (only for
power tools equipped with a manual fuel
pump). Do not start the engine if there
are leaks or damage – risk of fire. Have
the power tool repaired by a STIHL
servicing dealer before using it.
WARNING
Never operate your power tool if it is
damaged, improperly adjusted or
maintained, or not completely and
securely assembled.
To reduce the risk of injury, do not
operate your blower unless it has a
properly mounted blower tube.
WARNING
Check that the spark plug boot is
securely mounted on the spark plug – a
loose boot may cause arcing that could
ignite combustible fumes and cause a
fire.
Keep the handles clean and dry at all
times; it is particularly important to keep
them free of moisture, pitch, oil, fuel mix,
grease or resin in order for you to
maintain a firm grip and properly control
your power tool.
For specific starting instructions, see the
appropriate section of your instruction
manual.
Starting
WARNING
Start the engine at least 10 feet
(3 meters) from the fueling spot,
outdoors only.
WARNING
Your power tool is a one-person
machine. Do not allow other persons in
the general work area, even when
starting.
For specific starting instructions, see the
appropriate section of your manual.
Place the power tool on firm ground or
other solid surface in an open area.
Maintain good balance and secure
footing.
WARNING
To reduce the risk of injury from loss of
control, do not attempt to "drop start"
your power tool.
WARNING
When you pull the starter grip, do not
wrap the starter rope around your hand.
Do not let the grip snap back, but guide
the starter rope to rewind it properly.
Failure to follow this procedure may
result in injury to your hand or fingers
and may damage the starter
mechanism.
English
7