Cooper Lighting Solutions PORTFOLIO LDSSQ4 Instrucciones De Instalación página 4

Installation Instructions – LDSSQ4/LDSSQ6 Commercial Recessed LED Rough-In
Driver Replacement
WARNING
Risk of Fire, Electrical Shock, Cuts or
other Casualty Hazards- Installation and
maintenance of this product must be
performed by a qualified electrician. This
product must be installed in accordance
with the applicable installation code by
a person familiar with the construction
and operation of the product and hazards
involved.
Risk of Fire and Electric Shock- Make certain
power is OFF before starting installation or
attempting any maintenance. Disconnect
power at fuse or circuit breaker.
To avoid possible electrical shock, be sure that the power is
turned off before installing or servicing this fixture.
• The driver should be replaced by a qualified electrician.
• The driver may be replaced either from below or above the
ceiling.
1. Remove trim assembly from the housing (Figure 6).
2. Remove the driver and junction box cover assembly.
(Figure 10).
3. Disconnect the wiring to the driver by undoing the lever
nut connectors then cut the red and blue wires.
4. Discard the old driver and junction box cover assembly.
5. Connect the new driver leads with the lever nut
connectors.
6. Reattach the new driver and junction box cover
assembly.
Figure 9
4
Installation Instructions – LDSSQ4/LDSSQ6 Commercial Recessed LED Rough-In www.cooperlighting.com
Driver
Figure 10
Lever Closed
Close Lever To
Secure Wire
Figure 11
Wiring diagram B rev:
Wiring diagram C rev:
Lever Open
Open Lever To
Release Or Insert
Wire