Manual Time Setting - Techno Line WT 590 Manual De Instrucciones

DCF-77 Tower icon
Time
Date display
Indoor temperature
display in degree
Celsius
Seconds display
Alarm time display

MANUAL TIME SETTING:

Hours Setting
(flashing)
In some cases after inserting the batteries, the Projection clock may not be able to receive the DCF-77signal. In
this situation, the time should be manually set (before manual setting see Checking DCF-77 Reception
above).
1. Immediately after inserting the battery, press and hold down the MODE/MIN key until the time on the LCD
starts flashing.
2. Set the time by using the AL/HR and the MODE/MIN keys respectively.
3. Press the SNOOZE key to enter the Calendar setting mode or wait for about 8 seconds for automatic
timeout.
Note: The Projection clock will still try and receive the signal despite the time being manually set. When it
receives the signal, then the DCF tower icon will stay fixed on the LCD. If reception has been
unsuccessful, then the DCF tower icon will disappear but reception will still be attempted the following
hour.
CALENDAR SETTING
The date default of the Projection Alarm clock is MO 1.1. in the year 2000. Once the radio-controlled time
signals are received, the date is automatically updated. However, if the signals are not received, you can adjust
the date manually. To do this:
1. The year digits start flashing. Use the MODE/MIN key to set the year (the range runs from 2000 to 2029).
Minutes Setting
(flashing)