Stihl TS 700 Cutquik Manual De Instrucciones página 27

English / USA
4
3
: Turn the guard in the direction of the
arrow until the adjusting lever points
forwards.
: Unscrew the banjo bolt (3) and
remove it with the gasket.
: Remove the square nut from the
guide from the inboard side of the
guard.
: Take out the screw (4).
: Turn the adjusting lever upwards
and remove.
26
4
3
5
: Fit the adjusting lever (5) in position
A.
: Screw in and tighten down the
screw (4).
: Insert the square nut into the guide
in the connector and hold it in place.
: Screw the shorter banjo bolt (3) with
gasket onto the adjusting lever and
tighten it down.
: Turn the guard in the direction of the
arrow until the adjusting lever points
forwards.
A
7
To relax the V-belt,
: Unscrew the hexagon bolts (6) and
: turn the tensioning nut (7)
counterclockwise with the
combination wrench –
approx. 1/4 turn, until it reaches "0".
: Remove the hexagon bolts.
: Pull the V-belt guard (8) off to the
front and remove the V-belt from the
front belt pulley.
: Remove the bearing (9) with guard.
6
6
6
8
9
TS 700, TS 800