Feet; The Handle Installing; To Remove A Shelf; Electrical Connection - CASO DESIGN 694 Manual De Instrucciones

 For energy saving reasons please ensure that the door is closed when the appliance is
turned on.
13.5.2

Feet

There are different feet (3 bigger feet and 1 small foot). To level your appliance, adjust the
small foot at the bottom of the appliance.
13.5.1

The handle installing

The Barbecue Cooler comes with one handle. To install simply screw them to the door
with the supplied screws. To do this, slide the rubber seal on the back of the door to the
side to lay open the predrilled holes. Use the included screws to install the handle on the
door. Then reinsert the rubber seal in the correct position.
13.5.2

To remove a shelf

Remove all bottles from the shelves. Lift the shelf upwards and the gently pull it out,
(eventually untighten the screws).
► Ensure that the shelves are firmly engaged in place before storing any bottles.
► Pay attention for a uniform disposition of the bottles in the device.

13.6 Electrical connection

In order to ensure the safe and trouble-free operation of the device, the following
instructions must be observed for the electrical connection:
 Before connecting the device, compare the connection data (voltage and frequency) on
the rating plate with those of your electrical network. This data must agree in order that
no damages occur in the device. If in doubt, ask your qualified electrician.
 The connection between the device and the electrical network may employ a 3 meter
long (max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs
or gangs is prohibited because of the danger of fire that is involved with this.
 Make sure that the power cable is undamaged and has not been installed under or over
hot or sharp surfaces.
 This unit is not designed to be installed in an RV or used with an inverter.
 The electrical outlet must be protected by a 16A safety cut-out switch.
 The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. If in doubt, have the house installation
checked over by a qualified electrician.
The manufacturer cannot be made responsible for damages that are caused by a
missing or damaged protective conductor.
Please note
29