Fault Indications And Rectification Of Faults; Disposal Of The Old Device - CASO DESIGN 694 Manual De Instrucciones

17.2 Fault indications and rectification of faults

The following table assists in localizing and rectifying minor faults.
Fault
Your device is not cold
enough or it does not
reach the adjusted
temperature:
The light does not work.
Vibrations & too much
noise & door does not
close properly
Compressor will not start
Dew on the surface of
cabinet：
Liquid sound
Condensation formed
inside the cabinet
Error code E2
► If you are unable to solve the problem with the steps shown above, please contact
Customer Service.

18 Disposal of the Old Device

Old electric and electronic devices frequently still contain valuable materials.
However, they also contain damaging substances, which were necessary for
their functionality and safety.
If these were put in the non-recyclable waste or were handled incorrectly, they could be
detrimental to human health and the environment. Therefore, do not put your old device
into the non-recyclable waste under any circumstances.
► Utilise the collection point, established in your town, to return and recycle old electric
and electronic devices. If necessary, contact your town hall, local refuse collection
service or your dealer for information.
► Ensure that your old device is stored safely away from children until it is taken away:
Before you throw away your old refrigerator take off the doors and leave the shelves in
place, so that children may not easily climb inside.
Possible Cause
Check the temperature control setting.
External environment may require a higher setting.
The door is open too often. The door is not closed completely.
The door seal does not seal properly.
The refrigerator does not have the correct clearance.
Defrost the device.
Contact customer service.
Check to assure that the wine refrigerator is level. Check the fan.
Components are loose. Device touches the wall. The door is
reversed and not properly installed.
The seal is weak. The shelves are out of position.
Room temperature is lower than desired temperature.
The surface of refrigerator especially the glass door appear
some frost if item in a damp room. This is due to the moisture in
the air coming into contact with the cabinet. Please wipe it away
with dry cloth.
1) The sound of compressor when starts or stops working
2) The flowing sound of refrigerant in the refrigeration system
3) The evaporating sound of refrigerant in the evaporator
Under the environment with high level of humidity or the door of
wine cabinet has been left open for a long period or opened
frequently, wipe off the door and walls. Open the door as rarely
as possible.
Desired temperature is not reached.
If necessary defrost the device (Please follow the hints for
manual defrosting in chapter cleaning).
Please note
Please note
32