Warranty Conditions - GYS NEOMIG-i 400 G Manual De Uso

User manual
The weld bead is porous.
Excessive sparks.
No gas coming from the torch.
Error while downloading.
Backup error.
Automatic deletion of JOBS.
USB key error.
File error.
Update problem

WARRANTY CONDITIONS

The warranty covers any defects or manufacturing faults for two years from the date of purchase (parts and labour).
The warranty does not cover:
• Any other damage caused during transport.
• The general wear and tear of parts (i.e. : cables, clamps, etc.).
• Incidents caused by misuse (incorrect power supply, dropping or dismantling).
• Environment-related faults (such as pollution, rust and dust).
In the event of a breakdown, please return the item to your distributor, along with:
- dated proof of purchase (receipt, invoice, etc.),
a note explaining the malfunction.
24
Translation of the original
instructions
The gas flow is insufficient.
Gas cylinder empty.
Unsatisfactory gas quality.
Air circulation or wind influence.
Gas nozzle is too clogged.
Bad wire quality.
Condition of the welding surface is too poor
(rusted, etc.).
The gas is not connected.
Arc voltage is too low or too high.
Poor earth connection.
Insufficient gas protection.
Poor gas connection.
Problem with the gas bottle
The data on the USB stick is incorrect or
corrupted.
You have exceeded the maximum number of
backups.
Some of your JOBs have been deleted
because they were incompatible with the new
pre-installed user settings (synergies).
There is no JOB detected on the USB stick.
The product's memory space is full.
The file does not match the pre-installed
user settings (synergies) downloaded to the
product.
The USB stick is not recognised. The visuali-
sation of step 4 of the update procedure does
not appear on the display.
NEOMIG-i 400 G / 500 G
Adjustment range from 15 to 20 L / min.
Clean the base metal.
Replace it.
Replace it.
Avoid draughts and protect the welding area.
Clean or replace the gas nozzle.
Use a wire suitable for MIG/MAG welding.
Clean the workpiece before welding.
Check that the gas is connected to the power
source's inlet.
See welding settings.
Check and position the earth clamp as close
as possible to the area to be welded.
Adjust the gas flow.
Check the connections of gas inlets.
Check that the solenoid valve is working.
Check the gas level.
Check the gas supply.
Check your data.
You need to delete some programs.
The number of backups is limited to 200.
-
-
Free up some space on the USB key.
The file was created with pre-installed user
settings (synergies) that are not present on the
machine.
1- Insert the USB key into its socket.
2- Turn on the power source.
3- Press and hold the 2 push-buttons (no. 2
and no. 3) on the HMI to force the update.