Safety Instructions - HBM SomatXR MX Serie Guía Rápida

Safety instructions

1 Safety instructions
Appropriate use
The module and the connected transducers may be used for measurement
and directly related control tasks only. Any other use is not appropriate.
To ensure safe operation, the module may only be used as specified in the
operating manual. It is also essential to follow the respective legal and safety
regulations for the application concerned during use. The same applies to the
use of accessories.
Each time, before starting up the modules, you must first run a project planning
and risk analysis that takes into account all the safety aspects of automation
technology. This particularly concerns personal and machine protection.
Additional safety precautions must be taken in plants where malfunctions could
cause major damage, loss of data or even personal injury. In the event of a
fault, these precautions establish safe operating conditions.
This can be done, for example, by mechanical interlocking, error signaling, limit
value switches and such.
Safety rules
Notice
A module must not be connected directly to a DC power supply network. The
permissible supply voltage is range is 10 ... 30 V .
DC
The supply connection, as well as the signal and sense leads, must be
installed in such a way that electromagnetic interference does not adversely
affect device functionality. (HBM recommendation: "Greenline shielding
design," downloadable from the Internet at www.hbm.com.)
Automation equipment and devices must be covered over in such a way that
adequate protection or locking against unintentional actuation is provided (such
as access checks, password protection, etc.).
SomatXR 3
A04087_07_Z00_00 HBM: public