Tabla de contenido
Idiomas disponibles
Idiomas disponibles
16.2.5 Replacing the Grinding Wheel
Do not install a brush in the grinding wheel housing or vice versa.
Always replace a disc with a model of the same mass and size.
Replace the grinding wheel as soon as its diameter is 140 mm or less. Do not mount
or use discs with a diameter less than 140 mm. Do not use damaged discs.
Only use "glazed" grinding wheels with an indicated speed equal to or greater than
that indicated on the type plate of the tool (see imprint on the grinding wheel).
Integrity check of a new disk:
Before mounting a new disc, sound test it to check its general condition. To perform this test, the
disc must be dry and clean, otherwise the radiated sound may be attenuated.
To verify identity, lightly tap the side of the disc with a non-metallic object (wooden handle of a
screwdriver, rubber hammer).
An undamaged grinding wheel produces a clear sound, a damaged one a dull or rattling sound.
Disc Exchange procedure:
8. Replace the used grinding wheel (5) with a new one. (Make sure that the flanges and the
mounting shaft are clean before remounting a grinding wheel.)
9. Check that the bore of the grinding wheel matches the shaft of the grinding wheel. Use
reducing rings if necessary.
10. Fit the outer grinding wheel flange again.
11. Screw on the fixing nut again and tighten it firmly, but without exaggerating.
12. Remount the outer grinding wheel housing.
13. Make sure that the lateral distance between the grinding wheel and the housing is less
than ten millimetres.
14. Assemble the previously dismantled elements.
16.2.6 Replacing the Brush
Do not install a grinding wheel in the brush housing or vice versa.
Always replace the brush with a model of the same mass and size.
Do not use a worn or damaged brush.
Only use brushes with an indicated speed equal to or greater than the speed
indicated on the tool's nameplate (see the imprint on the brush).
Disconnect the power supply before performing this operation.
Do not install any wheels in the brush housing.
Always replace the brush with a model of the same mass and size.
Do not use a brush when it is worn, damaged.
HOLZMANN MASCHINEN GmbH
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
www.holzmann-maschinen.at
NOTE
1. Make sure that the machine is disconnected
from the mains.
2. Remove spark protection (8) and workpiece
support (10).
3. Remove the outer grinding wheel housing (1) by
loosening the screws.
4. Hold the motor shaft in position with a flat
spanner at the shaft end.
5. Unscrew the washer nut (2) with a wrench.
6. The left-hand side nut has a left-hand thread,
i.e. it must be loosened in a clockwise direction.
7. Remove the outer grinding wheel flange (3).
NOTE
27
DSM200DS
Tabla de contenido
