Tabla de contenido
Idiomas disponibles
Idiomas disponibles
12. Turn the lever clockwise until the sprocket cover is
secured then return it to the original position.
Fig.15
► 1. Lever 2. Sprocket cover
Removing the saw chain
To remove the saw chain, perform the following steps:
1.
Release the chain brake by pulling the front hand
guard.
2.
Turn the adjusting dial to "-" direction to release
the saw chain tension.
1
Fig.16
► 1. Adjusting dial
3.
Pull the lever up while pressing its edge.
1
Fig.17
2
► 1. Lever
4.
Turn the lever counterclockwise until the sprocket
cover comes off.
1
Fig.18
► 1. Lever 2. Sprocket cover
5.
Remove the sprocket cover then remove the saw
chain and guide bar from the chain saw body.
Adjusting saw chain tension
CAUTION:
ing or removing saw chain in a clean place free
from sawdust and the like.
CAUTION:
much. Excessively high tension of saw chain may
cause breakage of saw chain, wear of the guide bar
and breakage of the adjusting dial.
CAUTION:
jump off the bar and it may cause an injury
accident.
12 ENGLISH
Carry out the procedure of install-
Do not tighten the saw chain too
A chain which is too loose can
1
2
Tabla de contenido
