Preventive Maintenance Schedule - Uline H-10066 Manual De Instrucciones

WARNING! Unintended actuation of trigger
and safety latch during maintenance work
could lead to injuries. Always remove battery
before performing cleaning or preventive and
corrective maintenance work.

PREVENTIVE MAINTENANCE SCHEDULE

Clean stapler weekly (for approximately 100-300
staplings per day).
NOTE: It is recommended to have stapler
inspected every two years by a qualified
service technician.
CLEANING THE STAPLER
NOTE: In the case of heavy dirt accumulation,
it is recommended that the stapler be cleaned
regularly (daily). In particular, the driver blade,
the box detection and the clinchers should be
checked for damage and kept clean.
CAUTION! Keep moisture away from stapler.
NOTE: After removing battery from stapler,
clean the area of the clinchers, base plate,
box detection and magazine with a clean rag.
For better access, remove magazine.
If necessary, clean/replace the driver blade/
clinchers.
REMOVING JAMMED STAPLES
1. Remove battery from stapler.
2. Remove magazine.
3. If necessary, remove rear body and/or
protection plate.
4. Using a pair of pliers, remove the jammed staple.
5. Reinstall parts and insert battery.
PAGE 10 OF 42
MAINTENANCE
REMOVING/INSTALLING THE MAGAZINE
REMOVING
1. Remove battery from stapler.
2. Press quick release buttons (1) on left and right side
of stapler and pull magazine (2) backward then
downward. (See Figure 24)
Figure 24
INSTALLING
Installation is performed in reverse order.
NOTE: When installing the magazine (2),
ensure quick release buttons (1) are flush with
the housing. Only then is the latching of the
magazine ensured and no malfunction
(staple jam) can occur as a result.
1
2
1022 IH-10066