Intended Use; Power Supply - Makita 2704N Manual De Instrucciones

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Arbor hole
(Country specific)
Blade diameter
Max. cutting capacities
No load speed
Table size (L x W)
Dimensions (L x W x H) with
table(s) not extended
Net weight
Safety class
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s). The lightest and heaviest combination, according to
EPTA-Procedure 01/2014, are shown in the table.
Symbols
The followings show the symbols which may be used
for the equipment. Be sure that you understand their
meaning before use.
Read instruction manual.
DOUBLE INSULATION
Wear safety glasses.
Do not place hand or fingers close to the
blade.
Only for EU countries
Due to the presence of hazardous compo-
nents in the equipment, used electrical and
electronic equipment may have a negative
impact on the environment and human health.
Do not dispose of electrical and electronic
appliances with household waste!
In accordance with the European Directive
on waste electrical and electronic equipment
and its adaptation to national law, used
electrical and electronic equipment should
be collected separately and delivered to
a separate collection point for municipal
waste, operating in accordance with the
environmental protection regulations.
This is indicated by the symbol of the crossed-
out wheeled bin placed on the equipment.
bevel 0°
bevel 45°
with sub tables (R) and (back)
with sub table (R)
without sub table (back)
with sub tables (R) and (back)
with sub table (R)
without sub table (back)
1,045 mm x 1,066 mm (tables extended)
665 mm x 753 mm (tables stored)
567 mm x 1,066 mm (table extended)
567 mm x 753 mm (table stored)
715 mm x 753 mm x 483mm
665 mm x 753 mm x 483 mm

Intended use

The tool is intended for cutting in wood.
Straight cutting, bevel cutting, and miter cutting are
available with this tool. This tool is not designed for non-
through cutting.

Power supply

The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted noise level determined accord-
ing to EN62841-3-1:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
NOTE: The declared noise emission value(s) has
been measured in accordance with a standard test
method and may be used for comparing one tool with
another.
NOTE: The declared noise emission value(s)
may also be used in a preliminary assessment of
exposure.
9 ENGLISH
2704N
30 mm / 25.4 mm
260 mm
93 mm
64 mm
-1
5,200 min
35.2 kg - 37.0 kg
/II
) : 94 dB (A)
pA
) : 107 dB (A)
WA