Technical Data; Unpacking; Installation - Scheppach NTS30 Premium Traducción Del Manual De Instrucciones Original

In addition, these substances may cause the appliance
materials to corrode.
m WARNING!
This electric tool generates an electromagnetic field
during operation. This field can impair active or pas-
sive medical implants under certain conditions. In or-
der to prevent the risk of serious or deadly injuries,
we recommend that persons with medical implants
consult with their physician and the manufacturer of
the medical implant prior to operating the electric tool.

6. Technical Data

Mains voltage
Power
Maximum device socket power
Total power
Water tank capacity
Suction performance
Protection category
Protection class
Technical changes reserved!
7.

Unpacking

Open the packaging and remove the device carefully.
Remove the packaging material as well as the pack-
aging and transport bracing (if available).
Check that the delivery is complete.
Check the device and accessory parts for transport
damage.
If possible, store the packaging until the warranty pe-
riod has expired.
Familiarise yourself with the product by means of the
operating instructions before using for the first time.
With accessories as well as wearing parts and replace-
ment parts use only original parts.
Replacement parts can be obtained from your dealer.
When ordering please provide our article number as
well as type and year of manufacture for your equip-
ment.
m ATTENTION!
The device and packaging materials are not toys!
Children must not be allowed to play with plastic
bags, film and small parts! There is a risk of swal-
lowing and suffocation!
20 | GB
220-240 V~ 50/60 Hz
1300 W
2000 W
3300 W
30 L
20 Kpa
IP24
I
www.scheppach.com

8. Installation

m IMPORTANT!
Prior to use, ensure that the device has been correct-
ly and fully assembled.
Unpacking (Fig. A, B, C)
• Release the locking hooks (4) and remove the ma-
chine head (2). The accessories are located inside
the stainless steel container (8). Only the metal ex-
tension tube (g) is located outside the stainless steel
container (8) in the packaging. Remove all of the
accessories from the stainless steel container (8).
Installing the castor mounts (5a) (Fig. D)
• Turn the stainless steel container (8) upside-down.
(The machine head (2) must be removed).
• Push the castor mounts (5a) into the cut-outs provid-
ed on the wheel mounting base (6)
Installing the castors (5) (Fig. D)
• Press the four castors (5) into the holes in the castor
mounts (5a).
Installing the machine head (2) (Fig. E)
• Place the machine head (2) on the stainless steel
container (8). Secure the machine head (2) with the
locking hooks (4). When installing the machine head
(2), ensure that the locking hooks (4) latch into place
correctly.
Installing the foam filter (b) (Fig. F)
Never use the device without filter! Always ensure that
the filters are correctly fitted!
• Installing the foam filter (b): For wet vacuuming, slide
the foam filter (b) provided over the filter basket with
safety float valve (14).
Installing the HEPA filter (d) (Fig. G)
For dry vacuuming, slide the HEPA filter (d) provided
over the filter basket with safety float valve (14).
Installing the paper filter bag (c) (Fig. H)
It is recommended to use an additional paper filter bag
(c) when vacuuming fine, dry dirt.
• Slide the paper filter bag (c) over the suction opening
in the stainless steel container (8). The paper filter
bag (c) is only suitable for dry vacuuming. The paper
filter bag (c) makes it easier to dispose of the dust
collected.