Tabla de contenido
Idiomas disponibles
Idiomas disponibles
INTRODUCTION
This is an equipment used to test the automotive electrical system within 12-24 volts. In order to save
the testing hours for the automotive electrical system, it is designed to testing the system without re-
connection between the vehicle battery and the testing components. .
FUNCTIONS
•
Determine the polarity and circuit circumstance (short/ open).
•
Activating the components with positive or negative current without jumper wire.
•
Testing the voltage and continuity of the circuit.
•
Illumination.
•
Locate missing cylinders.
•
Measuring frequency of the high-tension ignition pulses and we could calculate the rotational
speed of engine according to the measured frequency.
•
Peak detection.
•
Testing the voltage of the circuit and the voltage reading will be indicated on the LCD display
within 1/10 of a volt.
WARNING
•
When current is provided to the unit, spark may be occurred when the tip contacts with ground or
certain circuits. Therefore please do not operate it around flammable.
•
Do not operating it with 110/220 volt house voltage as it is only for 12-24 volt system
•
Important: Read these instructions before using the device for the first time.
•
Be sure where you are testing, when applying positive and negative potential, components such
as Control module, potentiometer, etc. can be destroyed.
•
Manual transmissions always idle and automatic transmissions always insert "P". Faulty
measurements at the starter can be accidentally activated and can property damage and serious
injury.
•
Be careful when using the extended test tip, short circuit risk, because they are not isolated
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Multi-function Voltage Tester
Tel.: 02196 720480
Fax.: 02196 7204820
BGS 40105
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Tabla de contenido
