BGS technic 40105 Manual De Instrucciones página 12

SELF-TEST
If it is working correctly, the condition should be followed:
Red LED should be on when the technician push
the polar switch forward (toward the positive side).
Green LED should be on when the technician
push the polar switch backward. (toward the
negative side).
POLARITY TEST
If its tip is contacting with positive pole, the red
LED will be on.
If its tip is contacting with negative pole, the green
LED will be on.
If its tip is contacting with open circuit, neither LED will be on.
CONDUCTIVITY TEST
By using its tip assisting with ground test lead,
technician can test the conductivity between wires
or components which has been disconnected from
the vehicle electrical system. If the current is
conductible between wires or components, the
green LED should be on.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
[email protected]
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed