Bosch 0 275 U07 3SC Instrucciones De Servicio Originales página 327

Safety warnings for charging the battery
inside the remote control
Only charge the remote control with USB power
u
source (5 V, 600 mA max) and USB cable rated
at least 600 mA. Using USB power source or USB
cable not appropriately rated for the application
may result in fire, explosion or personal injury.
Charge the remote control in temperatures
u
above +32 degrees F (0 degrees C) and below
+104 degrees F (40 degrees C). Store remote
control in locations where temperatures will not
exceed 104 degrees F (40 degrees C). This is im-
portant to prevent serious damage to the battery in
the remote control.
Do not expose remote control to fire or exces-
u
sive temperature. Exposure to fire or temperature
above 212 °F (100 °C) may cause explosion.
Do not recharge the remote control (via USB
u
port) in damp or wet environment. Water enter-
ing remote control may result in electric shock or
fire.
Never submerge remote control in fluid of any
u
kind or allow fluid to enter them. Corrosive or
conductive fluid (such as seawater or industrial
chemical or bleach containing products, etc.) can
cause short circuit which may result in fire, per-
sonal injury and property damage.
Battery leakage may occur under extreme usage
u
or temperature conditions. Avoid contact with
skin and eyes. The battery liquid is caustic and
could cause chemical burns to tissues. If liquid
comes in contact with skin, wash quickly with soap
and water. If the liquid contacts your eyes, immedi-
ately flush eyes with water for a minimum of
15 minutes and seek medical attention.
Before each use, check the remote control, ca-
u
ble and plug. If damage is detected, do not use the
remote control. Damaged remote control, charging
cables and plugs increase the risk of a fire, explo-
sion and personal injury.
Bosch eBike Systems
Do not disassemble remote control. No user ser-
u
viceable part inside. Incorrect reassembly or dam-
age may result in fire or explosion.
NOTICE: This device complies with part 15 of the
FCC Rules. Operation is subject to the following two
conditions:
1. This device must not cause harmful interference,
and
2. this device must accept any interference received,
including interference that may cause undesired
operation.
NOTICE: Changes or modifications made to this
equipment not expressly approved by the Robert
Bosch GmbH may void the FCC authorization to oper-
ate this equipment.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device, pur-
suant to Part 15 of the FCC Rules. These limits are de-
signed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio fre-
quency energy and, if not installed and used in accor-
dance with the instructions, may cause harmful inter-
ference to radio communications. However, there is
no guarantee that interference will not occur in a par-
ticular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following mea-
sures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment
and receiver.
– Connect the equipment into an outlet on a circuit
different from that to which the receiver is con-
nected.
– Consult the dealer or an experienced radio/TV tech-
nician for help.
Radiofrequency radiation exposure Information:
The radiated output power of the device is far below
the FCC radio frequency exposure limits. Neverthe-
English – 5
0 275 U07 3RL | (09.03.2022)