EN
STARTER SET WIRELESS SWITCHING
1. Place the socket switch
A
Plug the socket switch into a power socket.
B
The socket switch will activate the pairing mode for 6
seconds.
2. Pair the socket switch with a transmitter
A
After plugging in the socket switch, send an ON-signal
with a channel on a Trust Smart Home transmitter while
the pairing mode is active.
B
The socket switch will make a clicking sound 4 times to
confirm the pairing has succeeded. The socket switch
can store up to 32 different transmitters in its memory.
The paired transmitters will be remembered when the
socket switch is moved to another power socket.
3. Operating the socket switch
A
Connect the device you want to control with the socket
switch and press the ON button with the assigned
channel on the paired transmitter to turn the socket
switch/device on. Do not exceed the maximum load:
2300W.
B
Press the OFF button with the assigned channel on the
paired transmitter to turn the socket switch/device off.
6
Optional: Unpair the socket switch from a
transmitter
A
Disconnect any connected device and remove the
socket switch from the power socket.
B
Plug the socket switch back in the power socket. The
pairing mode will be activated for 6 seconds.
C
While the pairing mode is active, send an OFF signal
with the assigned channel on the paired transmitter
to unpair it.
D
The socket switch will make a clicking sound 4 times.
Optional: Clear the memory of the socket switch
A
Disconnect any connected device and remove the
socket switch from the power socket.
B
Plug the socket switch back in the power socket. The
pairing mode will be activated for 6 seconds.
C
While the pairing mode is active, send a GROUP-OFF
signal with a transmitter to clear the memory.
D
The socket switch will make a clicking sound 4 times to
confirm the memory is cleared.
Replace transmitter battery
A
Open the battery compartment.
B
Place a new 3V CR2032 lithium battery. The polarity
should match the symbols on the holder.
C
Close the battery compartment.