Changing The Minimum Measurable Frequency; Changing The Continuity Test Alerts - Keysight Technologies U1231A Guia Del Usuario

Changing the minimum measurable frequency

This setting is used with frequency tests (see
measurable frequency will influence the display update rates for frequency
measurements. The typical display update rate as defined in the specification is
based on a minimum measurable frequency of 0.5 Hz.
Use this Setup item to adjust the minimum measurable frequency value (either
0.5 Hz or 5.0 Hz).
Parameter
FrEq
Figure 4-10

Changing the continuity test alerts

This setting is used with continuity tests (see
sound and the backlight to flash as a continuity indication whether the
circuit-under-test is less than (short) or more than or equal to (open) the threshold
resistance.
Keysight U1231A, U1232A, and U1233A User's Guide
Range
0.5 Hz or 5.0 Hz
P ress
P ress
Changing the minimum measurable frequency
Multimeter Setup Options
page 82). Changing the minimum
Defaul t setting
0.5 Hz
page 61). You can set the beeper to
4
113