Tabla de contenido
Idiomas disponibles
Idiomas disponibles
PARTS AND INSTALLING THE CONTROLLER
Parts
Remote controller
Remote controller
fixing screws (2EA)
Wall plate
Installing the Controller
Follow this procedure to install the controller
NOTE
• Do not bury the wired remote controller in the wall
(It may cause temperature sensor failure.) Cable
spec : 3 conductor, 22 AWG, unshielded, twisted,
and stranded.
• Do not install cables longer than 50m, as this may
cause communication problems.
• Install the product so that it doesn't bend or cause
a clearance with the wall.
• Incorrect wiring can cause damage to the product.
• To avoid damage by static electricity, touch metal
parts in the space before handling the remote
controller to discharge the static electricity from the
body.
• If the indoor unit does not have screw terminals
for field wiring, Extension cable PZCWRC1 is
required. The connector of this cable connects to
the indoor unit.
OWNER'S &
INSTALLATION MANUAL
PARTS AND INSTALLING THE CONTROLLER
1
Pull the cable from the wall and check the cable
direction to install.
2
Align the back cover and check the location of
two mounting holes on the wall.
3
Prepare by pulling out the communication cable
through center hole or top hole. (Figure.2)
4
Insert screws in mounting holes. (Figure.1)
NOTE
• Depending on your environment, you can install
the controller neatly by placing the wall plate on the
wall and tightening the back cover.
5
Connect the power cable to the terminal at the
bottom of the remote controller as shown in the
figure below.
GND / SIG / 12V
6
Place the lower part of the remote controller
under the back cover, and fix the power cable
to the back cover hook as shown in the figure
below to the place where the power cable will
come out of the back cover.
Wall
plate
or
Back
cover
(Figure.1)
Hook
To come out the power cable
upwards, use a nipper or nose
to remove the lower part.
(Figure.2)
7
7
Back
cover
Tabla de contenido
