Tabla de contenido
Idiomas disponibles
Idiomas disponibles
EN
MAINTENANCE
3. Remove the screws (4) and the arm (5).
4. Remove the swivel and replace it with a new one, or replace the seals. Make sure the seals are placed correctly (Fig. 8).
5. Grease the interior of the swivel and place it carefully back on the shaft until it touches the bearing on the spool.
6. Place back the rest of parts in reverse order.
Fig. 7
TROUBLESHOOTING
SYMPTOM
Hose does not rewind
Leaking hose reel
Leaking swivel
Hose does not extend out as much as required
Hose reel does not latch
DIMENSIONS AND PARTS LIST
SPARE PARTS SEE PAGE 20 AND 22
4
850 837 R. 02/22
Samson Corporation • One Samson Way • N.C. 28778 Swannanoa USA • Phone (828) 686-8511 • Fax (828) 686-8533
POSSIBLE CAUSES
Spring is not tensioned enough
Hose has a hole or is damaged
Damaged swivel rings
Spring is over tensioned
Damaged ratchet
Ratchet not fitted
Damaged spring ratchet
(Section of the swivel)
SOLUTION
Increase spring tension
Replace the hose
Replace the swivel rings
Decrease spring tension
Replace the ratchet
Assembly the ratchet properly
Change the ratchet spring
Fig. 8
Tabla de contenido
