MSW -MS-65 Manual De Instrucciones página 32

a) Fit the appropriate chisel/plane sharpening attachment on the device.
b) Place the blade by supporting it on the bracket on the attachment (see figure
3a) – the magnet retains the blade in place.
c) The sharpening angle must correspond to the angle of the workpiece blade, so
if necessary, adjust it by adjusting the knob (4) – to do this, loosen the knob
and set the angle, then tighten it again.
d) When it is ensured that the blade edge touches the whetstone, turn the device
on by using the ON/OFF button.
e) Move the blade up and down along the whetstone applying light, constant
pressure (figure 3d). Avoid keeping the blade in one, constant position, as this
results in uneven sharpening!
f) Gradually adjust the blade to the whetstone while sharpening (figure 3e) - do
not exert too much pressure on the blade. Sharpen the blade by repeating this
step.
g) Extend the blade to make sure that the bevelled edge and the blade itself are
sharpened evenly – if not, adjust the sharpening angle. It is important that the
sharpening angle is identical to the blade bevel angle in order to avoid
unnecessary removal of the blade material and to maintain its optimum
working angle (figure 3f).
CAUTION: in the case of sharpening thin chisel blades, use the provided guide
(2), which acts as a spacer. The sharpening itself should be done following the
same steps as explained above.
It is recommended that the blade is finished using an oilstone, which would
additionally protect it against rust.
h) After completing the sharpening and if the device is no longer used switch it
off with the ON/OFF button. Wait until the whetstone stops before removing
the attachment.