Installation Variants; Installation And Connection - Oase Aquarius Eco Expert 22000 Puesta En Marcha

1 Inlet (suction side)
• With filter cage (3) for submerged installation.
• With hose sleeve for connecting a hose for dry installation.
2 Outlet (pressure side)
• Connection of the return line into the pond (e.g. via a water course).
3 Filter cage
4 Foot
• With installation holes for firm installation on ground if required.
5 Power cable
• Pump power supply
6 Switch for switching on/off the dynamic function
• Numerous values for flow rates have been pre-programmed in the pump control system to cre-
ate a dynamic fountain with changing heights and diameters. If the dynamic function is acti-
vated, the pump is continuously controlled with these values.
7 Control system connection
• The OASE Eco Control control unit (accessory) is required for operating the pump.
• Alternatively, the pump can be integrated in an OASE Control network.
Hose sleeve ∅ 50 mm
• For information on OASE Control, visit www.oase.com.
Hose sleeve ∅ 38 mm
8
9
• Alternative for outlet Aquarius Eco Expert 22000 and 28000.
10 Hose clips for fastening hoses on the hose sleeves.

Installation variants

 A
• Variant (a): Submerged pump installation
– The pump is positioned in the pond.
– Water flow via the filter cage.
• Variant (b): Dry pump installation
– The pump is installed without the filter cage outside of the pond but lower than the water
level.
– Water flow via a satellite filter or skimmer.

Installation and connection

The pump can be installed submerged (in water) or dry (outside the water).
The use of the pump is only permitted with observance of the specified water quality.
• Pool water or salt water can impair the appearance of the unit. Such impairments are excluded
from the guarantee.
EN
13