Tabla de contenido
Idiomas disponibles
Idiomas disponibles
B
Using the appliance
Display
Intensive
For heaviest soiled crockery, and normally soiled pots,
pans, dishes etc. With dried-on food.
Universal
For normally soiled loads, such as pots, plates,
glasses and lightly soiled pans.
ECO
This is standard program, it is suitable to clean
Eco
normally soiled tableware and it is the most efficient
Program
5
program in terms of its combined energy and water
indicator
consumption for that type of tableware.
Glass
For lightly soiled crockery and glass.
90 min
90 '
For normally soiled loads that need quick wash.
Rapid
A shorter wash for lightly soiled loads that do not
need drying.
6
Screen
To show the reminding time, delay time, error code etc.
Rinse Aid
If the "
low on dishwasher rinse aid and requires a refill.
Salt
Warning
7
If the "
indicator
low on dishwasher salt and needs to be refilled.
Water Faucet
If the "
closed.
Water softener
• The water softener must be set manually, using the water hardness dial.
• The water softener is designed to remove minerals and salts from the water, which would
have a detrimental or adverse effect on the operation of the appliance.
• The more minerals there are, the harder your water is.
16
" indicator is lit, it means the dishwasher is
" indicator is lit, it means the dishwasher is
" indicator is lit, it means the water faucet
EN
B
Using the appliance
• The softener should be adjusted according to the hardness of the water in your area.
• Your local Water Authority can advise you on the hardness of the water in your area.
Adjusting salt consumption
• The dishwasher is designed to allow for adjustment in the amount of salt consumed based
on the hardness of the water used. This is intended to optimise and customise the level of
salt consumption.
• Please follow the steps below for adjustment in salt consumption.
1. Close the door, switch on the appliance;
2. Within 60 seconds after the appliance was switched on, press the Programme button for
more than 5 seconds to start the water softener setting mode;
3. Press the Program button again to select the proper setting according to your local
environment, the setting will change in the following sequence:
H1 -> H2 -> H3 -> H4 -> H5 -> H6.
4. Without any operation in five seconds or press the Power button to end the setting mode,
the setting is memorized by the programme.
WATER HARDNESS
Setting on the water
softener
°dH
Mmol/l
1)
2)
0 - 5
0 - 0,9
6 - 11
1,0 - 2,0
12 - 17
2,1 - 3,0
18 - 22
3,1 - 4,0
4 *
23 - 34
4,1 - 6,1
35 - 45
6,2 - 8,0
German degree of measurement for the water hardness
1)
millimol, internationel unit for water hardness
2)
Every cycle with a regeneration operation consumes additional 2.0 litres of water, the
3)
energy consumption increases by 0.02 kWh and the program extents by 4 minutes.
* factory setting
17
Regeneration
Digital display
occurs every
stalls
X program
sequence
1
H1
No regeneration
2
H2
10
3
H3
H4
5
H5
6
H6
EN
3)
5
3
2
1
Tabla de contenido
Solución de problemas
