Setting Up Your Phone; Charging The Phone - ZTE AXON 40 Pro Guia De Inicio Rapido

Setting Up Your Phone

The nano-SIM card(s) can be installed or removed while the
phone is turned on.
WARNING!
To avoid damage to the phone, do not use any other kind
of SIM cards, or any non-standard nano-SIM card cut from a
SIM card. You can get a standard nano-SIM card from your
service provider.
1. Insert the tip of the tray eject tool into the hole on the
card tray.
2. Pull out the card tray and install the nano-SIM card(s)
into the card slot(s) as shown. Carefully slide the tray
back into place.
CAUTION:
Never replace the included tray eject tool with sharp
objects. Ensure that the tray eject tool is perpendicular to
the hole. Otherwise, the phone may be damaged.
NOTE:
If two nano-SIM cards are installed, you can use either
card for mobile data and that card can connect to the 5G
network.
6

Charging the Phone

Your phone's battery should have enough power for the
phone to turn on, find a signal, and make a few calls. You
should fully charge the battery as soon as possible.
WARNING!
Use only ZTE-approved chargers and USB Type-C cables.
The use of unapproved accessories could damage your
phone or cause the battery to explode.
WARNING!
Do not remove the back cover. The battery is not
removable. Removal may cause fire or explosion.
1. Connect the adapter to the charging jack.
2. Connect the charger to a standard AC power outlet.
3. Disconnect the charger when the battery is fully
charged.
NOTE:
If the battery is extremely low, you may be unable to power
on the phone even when it is being charged. In this case,
try again after charging the phone for at least 20 minutes.
Contact the customer service if you still cannot power on
the phone after prolonged charging.
7